Standard Specifications

DIMENSIONS: Length up to 14600mm (48’) x 2500mm (8’ 2 ½”) wide. Top and bottom deck lengths to suit requirements. Deck height designed to suit turntable height of prime mover
CHASSIS: Fabricated ‘I’ Beam with 130mm x 12mm top flange and 130mm x 16mm bottom flange
COAMING RAILS: 100mm x 45mm High Tensile RSJ with 25 N.B. pipe tie rail.
Option: 125mm x 65mm RSJ
CROSSMEMBERS: 100mm x 45mm RSJ
Option: Container beams to suit 1 x 40ft., 2 x 20ft., or 1 x 20ft
FLOOR: 3mm chequer plate
Option: 2.5mm smooth steel or extruded aluminium floor
AXLES: York Model 2782 – 20” spider
Option: Various Axle brands and models available
TYRES: Nil. (Range available)
RIMS: Nil. (Range of steel spider, 10 stud steel or aluminium rims available)
SUSPENSION: York MT75 8’1” Spring Tri-axle cast steel overslung.
Option: Various spring or air suspension brands available.
KING PIN: 50mm Jost bolt-in (D-value 190kN) with bolt-on turntable block
BRAKES: Air Brake Corp Tri-axle to ADR 38/02 Specifications.
Option: Road train brake kit.
LANDING LEGS: Jost A400 Series
TYRE CARRIER: Dual through chassis type, with retainer straps
TOOLBOXES: One x 1200mm lockable type with spring loaded catches
Option: Additional toolboxes may be fitted.
WATER TANK: One x 60 litre galvanised
Option: Plastic water tank available
MUDGUARDS: Pressed aluminium tread plate guards with mudflaps front and rear of suspension
GATES: Pockets only. Front and rear load racks (height to suit)
Option: High tensile RHS single or twin bow gates with height as required. Tarp bow rack also available
LIGHTS: Lights (wired in conduit), Reflectors, and Rear Marker Plates conforming to all relevant Australian Design Rules
Option: LED lights – side and rear
PAINT: Trailer is deburred and fully sandblasted prior to painting with Etch Primer undercoat and PPG 2K finish coat to Fleet or Customer colours (with scrollwork to suit).
Option: Various finishes are available including Metallics, Clear-Over-Base, and Chemical resistant paints
OTHER OPTIONS: Hubodometer, Winches (clip-on or track type), Winch track, Rear Loading Ramps and/or Beaver Tail, Ringfeeder (bracket only or complete).

 

THESE SPECIFICATIONS ARE A GUIDE ONLY, AS EACH RHINO TRAILER CAN BE DESIGNED AND MANUFACTURED TO SUIT THE CUSTOMER’S SPECIFIC REQUIREMENTS

57 - 75 Industrial Avenue, Toowoomba, QLD, 4350                                                                  (07) 4634 7767 

Website Design by M Business & Marketing Solutions