STANDARD SPECIFICATIONS

DIMESNIONS: Length up to 14600mm (48’) x 2500mm (8’ 2 ½”) wide. Top and bottom deck lengths to suit requirements. Deck height designed to suit turntable height of prime mover
CHASSIS: Fabricated ‘I’ Beam with 130mm x 12mm top flange and 130mm x 16mm bottom flange
COAMING RAILS: 100mm x 45mm High Tensile RSJ with 25 N.B. pipe tie rail.
Option: 125mm x 65mm RSJ
CROSSMEMBERS: 100mm x 45mm RSJ
Option: Container beams to suit 1 x 40ft., 2 x 20ft., or 1 x 20ft
FLOOR: 3mm chequer plate
Option: 2.5mm smooth steel or extruded aluminium floor
AXLES: York Model 2782 – 20” spider
Option: Various Axle brands and models available
TYRES: Nil. (Range available)
RIMS: Nil. (Range of steel spider, 10 stud steel or aluminium rims available)
SUSPENSION: York MT75 8’1” Spring Tri-axle cast steel overslung.
Option: Various spring or air suspension brands available
KING PIN: 50mm Jost bolt-in (D-value 190kN) with bolt-on turntable block
BRAKES: Air Brake Corp Tri-axle to ADR 38/02 Specifications.
Option: Road train brake kit.
LANDING LEGS: Jost A400 Series
TRYE CARRIER: Dual through chassis type, hinged on rubber bushes
TOOLBOXES: One x 1200mm lockable type with spring loaded catches
Option: Additional toolboxes may be fitted.
WATER TANK: One x 60 litre galvanised
Option: Plastic water tank available
MUDGUARDS: Pressed aluminium tread plate guards with mudflaps front and rear of suspension
GATES: Pockets only. Front and rear load racks (height to suit)
Option: High tensile RHS single or twin bow gates with height as required. Tarp bow rack also available
LIGHTS: Lights (wired in conduit), Reflectors, and Rear Marker Plates conforming to all relevant Australian Design Rules
Option: LED lights – side and rear
PAINT: Trailer is deburred and fully sandblasted prior to painting with Etch Primer undercoat and PPG 2K finish coat to Fleet or Customer colours (with scrollwork to suit).
Option: Various finishes are available including Metallics, Clear-Over-Base, and Chemical resistant paints
OTHER OPTIONS: Hubodometer, Winches (clip-on or track type), Winch track, Spray Suppressant Mudguards and Flaps, Gate Rack, Ringfeeder (bracket only or complete), Large Toolbox (with or without shelf), Belly Tank, Spare Tyre Clamp, Rear mounted Fork Lift kit

 

THESE SPECIFICATIONS ARE A GUIDE ONLY, AS EACH RHINO TRAILER CAN BE DESIGNED AND MANUFACTURED TO SUIT THE CUSTOMER’S SPECIFIC REQUIREMENTS

57 - 75 Industrial Avenue, Toowoomba, QLD, 4350                                                                  (07) 4634 7767